mopaboxes.blogg.se - Free download jtag pinout

Default is to power Vcc(B) by TUMPA (3.3V only) (jumper on pin 1 and 2) Buffer chip 74LVC16T245 Vcc(B) power select jumper.Buffer enable jumper header for 74LVC16T245.Default force on (jumper is on pin 1and 2) Auto power down jumper header for MAX3243 (force on or auto power down).2x10 standard 20 PIN 2.54mm IDC JTAG connector (Channel A).2x3 standard 6 PIN 2.54mm IDC SPI connector (Channel A).Support both 32 bit and 64 bit operating systems.Free drivers for Windows XP, Windows Vista and Windows 7.USB over-current protection via on-board resetable fuse.1 2圆 10 PIN TTL level 2.54mm IDC header.1 2x5 10 PIN RS232 level 2.54mm IDC header.4 on-board LEDs / PWR, Targt PWR, TX and RX.

Target board can be powered by TUMPA (3.3V) or self powered (via jumper).

Configurable auto power down for MAX3243.

Configurable output of RS232 (MAX3243) or TTL level for serial communication.

On board voltage translation via 74LVC14T245 (can be enabled / disabled via software or jumper).

JTAG Baudrate up to 30Mbits/sec (programmable).

Thanks to stealther for creating the PDF manual. Looking for PDF version of this manual? It is here: It has two multi-protocol synchronous serial engines (MPSSEs) which allow for communication using JTAG, I2C and SPI on two channels simultaneously. The adapter is based on FDTI's flagship communication chip FT2232H, a USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC. The TIAO USB Multi Protocol Adapter (TUMPA) is a multi-functional USB communication adapter for hobbyists or engineers.

5.8 Serial RS232/TTL level Selection Jumperīuy various JTAG cables for your Satellite Receiver, Cable Modem, Wireless Router, Standard Wiggler from and.